The raw wooden surface to be coated should be clean, dry, free from moisture ,dampness and other contamination 

For hard wood, sand the surface using Sandpaper #80, followed by Sandpapers #120, #150, #180 and #220 

For Veneer ply surfaces,start with Sandpaper #220 

Always sand in the direction of the wood grain 

Mix the base thoroughly prior to mixing with the hardener 

Avoid applying in direct sunlight or when the humidity is very high 

WoodCoat Ultra White 

Apply 2 to 3 coats of WoodCoat Ultra Interior Sealer white with an interval of 2 hrs between the subsequent coats. Sanding should be done prior to the application of each coat 

Sandpaper #220 can be used for the first coat and Sandpaper #400 can be used for the second and third coats, number of coats of sealer required varies from 2 to 3 depending on the absorption of wood 

Apply 2 coats of either WoodCoat Ultra Interior High Gloss White / Matt White depending on the requirement, with an interval of 5 hrs between subsequent coats. Sanding of the first coat shall be done using Sandpaper #600 or #1000 

WoodCoat Ultra Other Shades 

Apply one coats of WoodCoat Ultra Interior Sealer white followed be 2 to 3 coats of WoodCoat Ultra Interior coloured sealer (tinted) with an interval of 2 hrs between the subsequent coats 

Sandpaper #220 shall be used for the first coat and Sandpaper #400 shall be used for subsequent coats 

Apply 2 coats of either WoodCoat Ultra Interior High Gloss Clear / Matt Clear depending on the requirement, with an interval of 5 hrs between subsequent coats. Sanding of the first coat shall be done using Sandpaper #600 or #1000 

Conventional Spray, Nozzle orifice: 0.059 inches, Pressure: 35 – 45 psi 

• Thinner Recommended – Thinner for finish