Metal

Ensure that the surface is dry, clean and free from impurities like oil, grease, loose rust and cracked or flaked paint

Sand the surface with #180 Sandpaper and ensure that no loose particles are present before priming. Wipe the surface clean

Wood

The raw wooden surface to be coated should be clean, dry, free from moisture, dampness and other contamination

Sand the surface using #80 Sandpaper, followed by grit sizes #120, #150, #180 and #220 Sandpaper

This step wise approach leads to a very smooth surface

Always sand in the direction of the wood grain. This step wise process is applicable only for hard wood. Start with #220 Sandpaper for Veneer/ Plywood

Metal

Apply 2 coats SPEP Primer Grey with an interval of 4-6 hours between subsequent coats either by spray or brush

The primed surface can be sanded using #220 Sandpaper after 10-12 hours of drying.

Appropriate filler to be used for filling dents and imperfections which should then be sanded and primed again.

Apply 2 coats of Specta Glossy/Stain shede with an interval of 6-7 hours by brush or spray.

Wood

Apply 2 to 3 coats of MRF Vapocure paints Wood Primer with an interval of 5-6 hours between subsequent coats.

Sanding should be done prior to application of Topcoat.

#400 Sandpaper can be used for sanding after 10-12 hours of drying.

Apply 2 coats of Specta Glossy/Stain shede with an interval of 6-7 hours by brush or spray.

• Mix the paint thoroughly prior to thinning 

• Thinner Recommended – Thinner 555