Durability
Gloss Resistant
Stain Resistant
Water Resistant
Scratch Resistant
The raw wooden surface to be coated should be clean, dry, free from moisture ,dampness and other contamination
For hardwood, sand the surface using Sandpaper #80, followed by Sandpapers #120, #150, #180 and #220
For Veneer ply surfaces,start with Sandpaper #220
Always sand in the direction of the wood grain
Mix the base thoroughly prior to mixing with the hardener. Avoid applying in direct sunlight or when the humidity is very high.
Apply 2 to 3 coats of WoodCoat High Solids Sealer clear with an interval of 8 hours between the subsequent coats. Sanding should be done prior to the application of each coat
Sandpaper #220 can be used for the first coat and Sandpaper #400 can be used for the second and third coats
The number of coats of sealer required varies from 2 to 3 depending on the absorption of wood. Apply 2 coats of either WoodCoat Exterior Glossy clear or WoodCoat Exterior Silky Matt clear depending on the requirement. Sand the first coat with Sandpaper #600, after 8 hours of drying
MRF Woodstains Exterior shades can be used to enhance the colour of the wood grain. The available shades can be used over either the first coat or the second coat of sealer clear sanding of the applied shade is not permitted
For exterior applications use Woodstains exterior shades only
Conventional Spray, Nozzle orifice: 0.059 inches, Pressure: 35 – 45 psi
- Thinner Recommended – Thinner for finish
WoodCoat High Solids Sealer Clear | 15 – 20% |
WoodCoat Ext.Glossy Clear | 30 – 35% |
WoodCoat Ext.Silky Matt Clear | 25 – 30% |
Other Products
Get a sneak peek!
Discover the possibilities!
Get a sample of a new world in
3 simple steps